Skip to main content

Hand crank for the X-Carve Z-axis

Marius Hornberger

Marius Hornberger

Published Aug 16, 2015

Favorite Preview

Description

During testing the X-Carve I often ran into the problem that I wanted to carve another shape and needed to change the bit. But I always had to lift up the spindle with the software. SO I decided to make a little hand crank that goes on top of the Z-axis for lifting the spindle up manually.

22 Favorites
97 Views
1 Comments
24 Copies

Specs

Material

Birch Plywood

License

Attribution 3.0 Unported (CC BY 3.0)

Instructions

1

Watch the project on YouTube

I put together a video on my YouTube channel that shows everything.

Estimated time: 2 minutes

2

Let the CNC do its work

Cut out the shape out of a material of your choice. I recommend birch plywood or the stuff I was using, which basically is birch plywood with a black resin coating. I chose it, because it's black and the machine is black, so...you get it.

Estimated time: 10 minutes

Hand crank for the X-Carve Z-axis — Let the CNC do its work
3

Adding the nut

I skipped the painting part, because it's painting and not very interesting. After painting put a nut in place.

Estimated time: 1 minutes

Hand crank for the X-Carve Z-axis — Adding the nut
4

Hammer in the nut

Just grab a hammer and pound the nut into place. You could also use a vice.

Estimated time: 1 minutes

Hand crank for the X-Carve Z-axis — Hammer in the nut
5

The knob

You can make the spinning knob in several ways. I made mine on my lathe, but a dowl with a hole through it, big enough for a screw, will do the job.

Estimated time: 5 minutes

Hand crank for the X-Carve Z-axis — The knob
6

Done

Simply screw the hand crank back on top of the Z-axis and your done.

Estimated time: 1 minutes

Hand crank for the X-Carve Z-axis — Done

Comments

Brian Gidney

Brian Gidney · August 17, 2015