Car headrest mount
Instructions
Carving
This design can be easily cut with little to no post processing and finishing and takes about 47 mins on the x-carve.
Estimated time: 47 minutes
Assembly
Once cut on the x-carve, the mount is easily assembled by means of a slotting system. A section of micro suction tape is then adhered to the large rectangular back plate surface.
Estimated time: 1 minutes
Installation
To install, first the headrest is removed. The left headrest post is positioned in one of the three different sized holes on the left of the mount. The right post is located in the slot on the right of the mount. The headrest posts are then re-positioned in the seat.
This configuration of slots and holes allows the headrest mount to be attached to a huge variety of headrests, with post diameters ranging from 10-14mm.
Estimated time: 1 minutes
Mount a device
To mount your tablet or phone, simple press the device firmly against the micro-suction tape on the back plate.
Once installed, the device bracket can be detached from the headrest rail mount. This feature gives the user the ability to store the extending portion of the mount without having to first remove the headrest.
Estimated time: 1 minutes
Comments
How does one contact the licensing person for a waiver to make this item.
Troy Stoneking · August 19, 2018
Hi Troy you're free to use the design for personal use. For commercial use, you can contact me at Salmon@yugen.co.za
Salmon · November 11, 2020