Marble Game

Sam Alaimo

Published Jun 14, 2017 · Carved

Favorite Preview

Description

Get all the marbles to the middle. This game is surprisingly harder than it looks! The slick design makes in a nice addition to a home or office.

77 Favorites

728 Views

1 Comments

362 Copies

Specs

Machine: carvey (grbl)
Material: Cast Acrylic, Hard Maple

Instructions

Carve the wood

Open the project and carve the Workpiece labeled "wood base". Any 1/2 wood or material should work.

Estimated time: 15 minutes

Carve the acrylic

Next, go to the Workpiece labeled "acrylic cover". Cut this out of any 1/16" thick acrylic.

Estimated time: 5 minutes

Add the bearings

I used 5/32 inch "Diameter Chrome Steel Bearing Balls":https://www.amazon.com/Diameter-Chrome-Steel-Bearing-Bearings/dp/B002BBIOIG for the balls in this game.

Estimated time: 1 minutes

Put the acrylic in

I was able to press fit the acrylic into the wood (I used the inlay app to get the measurements right). I didn't use any glue, and the top stays in nicely unless you bang in upside down on a table.

You can glue it if you would like!