Bandsaw box template
Project by
justin Bartlett
Published On
July 01, 2025
General Information
use this file as a template for a bandsaw box. 60 degree V bit at .10-.25 works great to give you an outline to follow with your blade. texturing was done by hand with a dremel tool.
Materials:
Birch Plywood
Machine Type:
X-Carve
Notes:
check dimensions before carving! carve the center. then carve the exterior and box at .10-20 with a 60 degree v bit. this allows your bandsaw blade to fall into the groove and guide along the cut. after pulling from the machine i used a dremel with a ball mill to texture between the "leaves".
Preview in Easel
Log in to post a comment to the designer