We use cookies to personalize content, interact with our analytics companies, advertising networks and cooperatives, and demographic companies, provide social media features, and to analyze our traffic. Our social media, advertising and analytics partners may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Learn more.
Thank you for sharing this project. It is my first 3D carve. Everything went well but my facial features didn't turn out on all the people. I am using 1/8 ball nose for finish and 1/8 down cut for rough. I set my depth to project the thickness of a piece paper. Any suggestions
I've ran this cut twice now and both times in the same spot about 2/3rd from the top the shifts and throws the cut off. At first I thought the workpiece slid but after repeating the same cut and reenforced the hold downs and seeing the same mistake, I'm left scratching my head.
Comments
Thank you for sharing this project. It is my first 3D carve. Everything went well but my facial features didn't turn out on all the people. I am using 1/8 ball nose for finish and 1/8 down cut for rough. I set my depth to project the thickness of a piece paper. Any suggestions
John WilliamsonPro · September 05, 2023
need to use a 2mm or smaller ball nose to get detail, and have less than 12% stepover.
MAGA V2 XL userPro · September 12, 2023
I've ran this cut twice now and both times in the same spot about 2/3rd from the top the shifts and throws the cut off. At first I thought the workpiece slid but after repeating the same cut and reenforced the hold downs and seeing the same mistake, I'm left scratching my head.
Nick McCartneyPro · December 13, 2023