10" x 16" Box

Published Jun 26, 2016

Description

This is a 10" x 16" box designed to cut in one piece of 7/16" material on a 1 square meter X-carve. The example was cut in 7/16" OSB. Stained a bit with Briwax (this might work better if done before assembly). The bottom is split into two pieces to optimize material usage and to fit in 800x800mm.

27 Favorites

235 Views

4 Comments

110 Copies

Specs

Material: Birch Plywood

Instructions

.

Feed your X-Carve an 32"x28" piece of 7/16" stock.
Fit a 1/8" bit (down cut if you have one).
Cut it out.
Clean up the tabs.
Glue it together. A brad nailer makes glue-up easier.

Comments

Not sure what I did wrong. All i got was the two sides, the top insert and one small piece that isn't fit anywhere. Suggestions? Dennis

Dennis ShermanPro · March 12, 2021

Hmm. Did you cut the right sheet? The first one is probably the one you want. The third one only includes those bits you mention. I think it was a recovery from a broken bit.

Kiera Malmin · March 12, 2021

Oddly it looks like the published version of this is linking directly to the one I use when I make new boxes....so it is changing through time, which is not ideal for a 'published' item. Sorry about that!

Kiera Malmin · March 12, 2021

Actually looking closer, the 4th and 5th panels go together. Cutting 2 of panel 4 and 1 of panel 5 will result in two boxes. Again apologies for the mixup, I did not realize I was changing the published version.

Kiera Malmin · March 12, 2021